We had a good meeting last night. Discussed:
- 3D modeling PhD thesis, presented by Peter, who promised to provide a link
- laser harp progress - Sauyon has the stepper motor stepping, Nathan has a good idea about the MIDI configuration, Cosmo is thinking about the 3D printed chassis, and Peter volunteered to research low mass mirrors
- The Tech Challenge - yes, we want to participate
- strip LEDs
We investigated a strip LED that cost under $5.
The strip can be cut at every third LED, so each maker took home about a meter in length.
To power it up, the makers had to look up the operating voltage, found a 12V power supply, measured the pinout, and then wired it up.
Alas, Peter left before we took photos.
NOTE: Follow this blog with the link to the right →
No comments:
Post a Comment